Hello. Your door sticks. You pull the handle. You lift the door. It scrapes the floor. It jams the frame. This happens often in North Vancouver. The air is damp. The wood swells. Houses settle. We help you fix it.
Randall The Handyman knows North Vancouver homes. We see these problems in Lynn Valley. We see them in Lonsdale. We fix them in Deep Cove. You want a door that swings. You want a door that latches. You want it done now.
Why Your Door Sticks
North Vancouver has high humidity. Wood absorbs moisture. The door grows larger. It hits the jamb. This is common in the rainy season.
Foundations move. The soil shifts. The frame goes out of square. One corner drops. The door hits the top. The door hits the side.
Hinges wear down. Screws pull out of the wood. The door sags. It leans away from the top hinge. It rubs the bottom of the frame.
Start With the Hinges
Open your door. Look at the top hinge. Check the screws. Use a manual screwdriver. Tighten every screw. Do not use a drill. A drill strips the wood. Feel the screw grab.
Look for gaps. A gap behind the hinge means trouble. Close the door. Watch the corner. See where it hits.
If the door sags, remove one short screw. Choose the hole closest to the wall. Grab a three-inch wood screw. Drive it through the hinge. Drive it into the wall stud. Watch the door move. The frame pulls back. The door rises. Test the swing.
Adjusting the Strike Plate
Your door closes. The latch hits the metal plate. It does not click. You have to push hard.
Look at the strike plate. Find the rub marks. The latch is too high or too low. Unscrew the plate. Remove it.
Use a small chisel. Remove a sliver of wood. Move the plate up or down. Hold it steady. Drive the screws into the new spot. Close the door. Listen for the click.
Sanding the Edges
Sometimes screws are not enough. The wood is too big. You must remove material.
Find the sticking point. Use a pencil. Scribble on the door edge. Close the door. Open the door. Look at the pencil marks. The marks rub off where the door hits.
Get a sanding block. Use 80-grit sandpaper. Rub the wood. Move back and forth. Remove a thin layer. Check the fit. Sand more if needed.
Stop when the door clears the frame. Switch to 120-grit sandpaper. Make the wood smooth. Apply a matching paint or stain. This seals the wood. It stops more moisture from entering.
Fixing Sliding Doors
North Vancouver has many patio doors. These doors are heavy. They slide on rollers. Dirt enters the track. The rollers wear out.
Vacuum the bottom track. Remove the hair. Remove the grit. Use a wet cloth. Wipe the metal clean.
Find the adjustment holes. They are at the bottom of the door. Use a flathead screwdriver. Turn the screw clockwise. This raises the door. Turn it counter-clockwise. This lowers the door.
Spray silicone lubricant. Do not use grease. Grease attracts dirt. Use silicone. Wipe the excess. Slide the door. Feel the difference.
Bifold and Closet Doors
Closet doors jump the track. They tilt. They scrape.
Look at the top pivot. It sits in a bracket. Loosen the adjustment screw. Move the pivot left or right. Center the door in the opening. Tighten the screw.
Check the bottom pivot. Lift the door. Place it in the floor socket. Adjust the height. Make the door level.
Tools You Need
You can do small fixes. You need basic tools.
- Phillips screwdriver.
- Flathead screwdriver.
- Three-inch wood screws.
- Sanding block.
- Silicone spray.
- Vacuum.
- Chisel.
If you lack these, call us. We bring everything.
When to Call a Pro
Some doors are difficult. Fire doors are heavy. Exterior doors have complex seals. Glass doors can break.
You might see rot. The wood feels soft. A screw will not hold. This requires a frame repair.
You might have a broken hinge. You might have a snapped cable. You might have a bent track.
Randall The Handyman handles these. We serve all of North Vancouver. We work in Capilano. We work in Seymour. We work in Norgate.
Our Simple Pricing
We keep pricing clear. You know the cost before we start.
The first hour is $120. Every additional hour is $85.
We work fast. We fix multiple doors in one visit. We check your hinges. We lubricate your tracks. We align your latches.
Most door repairs take one to two hours. You get a working door. You get peace of mind.
Maintaining Your Doors
Fix the problem early. A sticking door damages the frame. It stresses the hinges. It ruins the paint.
Wipe your tracks every month. Tighten your screws every year. Watch for seasonal changes.
If a door starts to rub, sand it immediately. Do not wait for it to jam.
Local Service Areas
We live and work here. We know the North Shore weather.
- Kerrisdale
- West End
- Yaletown
- East Vancouver
- UBC
- Westside
- South Vancouver
- Burnaby
- Richmond
- North Vancouver
- West Vancouver
We arrive on time. We bring a branded van. We wear a uniform. We respect your home.
Chain Actions for a Smooth Door
Follow these steps. Identify the rub, then tighten the hinges, then adjust the strike plate, then sand the edge, then seal the wood.
Test the door. Swing it wide. Close it slowly. Ensure the latch holds.
If the door still sticks, call Randall.
Contact Us Today
Visit randallthehandyman.com. Book your appointment online. Choose a time that works.
We fix sticking doors. We fix leaking faucets. We mount TVs. We assemble furniture.
Your North Vancouver home deserves care. Stop fighting your doors. Let them swing freely.
Call Randall The Handyman. Get it fixed today.
